AW Devices

Group Joiner

AW Devices Group Joiner - Auto Group Join

Let visitors join your group by themselves with just three clicks! COPY AND MODIFY ENABLED

In this page here we are explaining you about the group joiners requiring 3 clicks in order to join avatars to your group. These Group Joiners are available in 'Only Touch' and 'Touch and Sensor' models. AW Devices has also available a Group Joiner/Inviter with NO Human intervention required using a bot. Click here to get more info.

This NEW  device will, when touched, and also when detecte dby a sensor (optionally) send an IM to the avatar who touches the object. The IM contains an URL which, when clicked, will open the group window and allow the avatar to join the group. Also, it will notify you whenever somebody touches the object by IM and Email.

It also opens a blue window in top right corner of the screen giving the same information. This blue notices are easier to see than the IMs.

FEATURES

    - Let avatars join your group by themselves, no interaction needed
    - Group Serach not necessary
    - Use unlimited copies
    - Rez the Group Joiner or drop the script and setup note into YOUR own design prim
    - Receive an IM whenever somebody clicks the object
    - Receive an Email whenever somebody clicks the object
    - Fully notecard setup (keep setup data in memory even if you have to reset script)
    - No timers, no listeners, no sensors: NO LAG
    - Daily statistics Report sent to the email address you write in the setup notecard (only Touch & Sensor model)
    - Activate on touch and optionally by a sensor (only Touch & Sensor model)
    - Sensor reach and interval changeable (only Touch & Sensor model)
    - Invites only once a day (sensor)
    - Multi-touch event protection system (only Touch & Sensor model)
    - The prim is copy/mod/no transfer. The script is copy/no mod/no transfer. setup notecard is full perm
    - Mono Compiled


FAST SETUP

To configure Group Joiner follow these steps:

   1. Wear the tag of the group you wish to invite people into, or set Group Joiner group to the right one (it must be "Open Enrollment" to join)
   2. Rez the object and edit it (right-click and edit)
   3. Go to contents tab and open setup note
   4. Fill the lines of the note following the indications on it
   5. Save the note

Now you can touch the Group Joiner and test how it works.
For any question don't hesitate to IM Azul Wilder.

Go directly to the vendor in shop -> BUY
Buy it from SLX